EMC-ME0909 Motor
|
The Mars ME0909 is a Brush-Type, Permanent Magnet DC motor with very high efficiency. Capable of 4.8 KW continuous and 15 KW for 30 seconds. For voltages from 12 to 48 VDC input and 100 amps continuous (300 amps for 30 seconds). Designed for battery operated equipment. It makes a great replacement for the original Etek motor because it has the same bolt pattern and is actually lighter in weight.
Power: 4 cont-- 12.8 pk hp
Voltage: 12-48 Volt rated
Speed: 2150-4850 rpm
Size: 6" OD, (w/o shaft)
Shaft: 7/8"x 1-3/4", 3/16" key
Weight: 24 lbs.
Voltage Constant: 0.0107
Revolutions per volt: 93.45 RPM
Torque Constant: 0.102 Nm/Amp
Generated Current: 9.8A per Nm
|
Motor Controller
|
Choose from...
Alltrax AXE 4834 48V 300A
Sigmadrive PM4825 48V 250A 4Q w/ Regen
Sevcon MillipaK 48V 300A 4Q w/ Regen
|
Throttle 0-5k Ohm
|
Choose from...
Magura Twist-Grip Potentiometer Throttle
Light Weight Pot Box Throttle
EZ-GO Pot Box Throttle
Curtis PB-8 Pot Box Throttle
|
Contactor
|
Contactors (also known as solenoids) are used to connect and disconnect main battery buss power. When it is time to turn your vehicle on or off, the contactor will engage or disengage the power at the flip of a switch. This is very usefull in an emergency situation when main power needs to be turned off quickly and easily. It is highly recommended that an appropriate pre-charge resistor (included) and a contactor coil suppression diode (included) be used with any contactor system.
In general, your contactor's coil voltage should make the nominal voltage of your battery pack.
|
| Wire kit |
Electric Motorsport wire kit specifically designed for the EMC-ME0909 Electric Drive Kit.
|
| Fuse and Holder |
Fuse block |
